DriSteem Vapor-logic3 Installationshandbuch Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 22
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
DRI-STEEM Vapor-logic3 to Vapor-logic4 Adaptor Board Installation Manual Page 1
Table of contents
Warnings and cautions ................................ ii
Before beginning the upgrade........................... 2
Parts
............................................... 2
GTS humidifiers:
Board removal and replacement
Removing Vapor-logic3, installing Vapor-logic4. . . . . . . . . . . . . 3
Transferring expansion board terminal blocks ..............5
Keypad/display removal and replacement
Indoor GTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
GTS with outdoor enclosure ..............................6
Safety circuit wiring
Leave safety circuit wired in series with one alarm ........... 8
Separate safety circuit alarm signals into three alarms ........ 8
Electric humidifiers:
Board removal and replacement
Removing Vapor-logic3, installing Vapor-logic4. . . . . . . . . . . . 10
Transferring expansion board terminal blocks .............12
Keypad/display removal and replacement
Vaporstream and CRUV with mounted keypad/display .....13
Vaporstream and CRUV with unmounted keypad/display ...13
Vapormist and Humidi-tech .............................13
Safety circuit wiring .......................................14
STS humidifiers:
Board removal and replacement ............................16
Keypad/display removal and replacement
STS with mounted keypad/display ........................18
STS with unmounted keypad/display .....................18
Safety circuit wiring .......................................18
All Humidifiers:
Start-up and validation
Start-up ...............................................19
Test outputs ...........................................19
Test run ............................................... 19
Vapor-logic4 adaptor board pin descriptions ........ Back cover
Tools required:
Needle nose pliers / wire cutter
Wire stripper
#2 Phillips screwdriver
3/16" and 1/8" flat-tip screwdrivers
5/8" nut driver
Seitenansicht 2
1 2 3 4 5 6 7 8 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare