DriSteem GTS Spezifikationen PDF herunterladen (Seite 24)

MAINTENANCE

• Remove loose deposits and residue that falls into rear

header with a vacuum cleaner and hose extension.

• Inspect 2" return tubes and clean if necessary.

• Run thin brush between turbulator and tube wall on all

four sides.

• Reinstall burner assemblies and gaskets; vent box

andgasket; all electrical wiring; gas train shroud; and

pressure switch connections.

2. Burner: The burner surface is a self cleaning

ceramic fabric which does not require cleaning or

maintenance.

3. INSPECTION RECOMMENDATIONS by user every

30 days. Appliance system should be inspected

once a year by a qualified service person.

• Flue passageways external to the appliance such

as vent connector and chimney to be clear and

free of obstructions.

• Vent connector is in place, sloping upward and is

physically sound without holes or excessive

corrosion.

• Physical support of the appliance is sound without

sagging cracks, gaps...between floor stand legs

and tank flanges, or between trapeze bars and

tank bottom.

• Verify there are no obvious signs of deterioration

of the appliance.

• Burner flame will operate blue or orange in color -

up to a ¼" from the surface of the burner. See

figure 24-1.

• See "Cleaning Water Level Probes" and "Cleaning

Low Water Cut-Out Probe" on page 23.

2 1/4" Dia. Burner

Flame may appear blue at

start-up, then turn orange

after heat-up

OM-847

When servicing or repairing this equipment, use only

DRI-STEEM approved service replacement parts. A

complete replacement parts list are on pages 26 and

27. Refer to the rating plate on the unit for complete

unit model number, serial number and company ad-

dress. Any substitution of parts or controls not ap-

proved by DRI-STEEM will be at owner's risk and will

void the warranty.

Both GTS

and GTS-DI

Inspecting the Burner Assemblies and Heat

Exchanger Tubes

1. Note: Soot and carbon deposits may indicate a

combustion problem that needs to be corrected.

Consult the factory.

This is not regular maintenance, but if the heat

exchanger tubes contain carbon deposits, soot or

other residue, clean as follows:

• Turn off gas, electrical power, and water supply.

• Remove gas train shroud.

• Disconnect wiring to blowers, flame sensors, gas

valves, and ignition controllers.

• Remove burner assemblies (each assembly is

mounted with four bolts).

• Remove vent box.

• Use a four-inch flue brush with a 28" extension and

reversible drill. Work brush in and out of all four fire

tubes.

Figure 24-1: Burner Assembly Flame

GTS-IOM-1298.pdf 24 11/17/2009 3:57:05 PM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

DriSteem GTS Spezifikationen Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftentfeuchter DriSteem GTS